- 0Cart
-
Your shopping cart is empty.
-
more items in the cart...
Cart Total: $0.00
Proceed to Checkout
Your shopping cart is empty.
Cart Total: $0.00
Proceed to Checkout
Item specifics
Product Description
VDIAGTOOL vc100 VC-100 Digital Backlight LCD Film Thickness Meter Car Paint Thickness Tester Coating Thickness Gauge Best testerDifference between VC100, VC200 and VC300.
Car Paint Tester Introduction Car Paint Tester IntroductionThe Car Paint Check meter is a portable obd2 obdii coating thickness gauge,which can meansure the thickness of non-metallic coating(such as paint,film,etc.) On netal substrate quickly,nondestructively,and accuratly. The gauge takes the precision integrated probe, and uses principles of electro-magnetic induction and the eddy current effect, which automatically detects the attribute of substrates. The Gauge is designed for non-destructively measuring the thickness of coating and painting. It is essential for material surface treatment and widely used in manufacturing industry, metal-processing industry, chemical industry, commodity inspection area, and also able to work steadily in the laboratory, workshop and outdoor VC100 Thickness Gauge Digital VC100 can Test Paint thickness , can help you test whether the thickness of the paint is normal when you buy a used car and whether it has been repaintedindustries. Use VC200 to measure the comparison of painted cars and non-painted cars Car Paint TesterButton Functions 1.Botton"CLR":Turn on/off,clear.2.Botton"UNIT":Unit Switch,backlightCar Paint Tester Operation Instructions 1.Measurement preparation Open battery cover and load two CR2032 button batteries(Not Includes); Pay attention to positive and negative pole. 2.Turn on/off Leave the instrument hang in the air and press"CLR"button to turn it on,LCD full screen display,which means it enters the measurement state.Then long press"CLR"button to turn it off. Note:Keep it away from the substrate when starting up. 3.MeasurementPress the probe onto the coated metal substrate lightly,ensure that the instrument should be perpendicular to the surface of the object that being measured.Note:When the probe was pressed on the substrate,the LCD will display"---",then you must wait unit the measurement value displayed the LCD,then remove it from the substrate.If removing before a value is displayed,it will display the last measured value.4.Unit selectionAfter start-up,short press"UNIT"button to select measurement unit mm or mil.5.LCD backlightAfter start-up,long press"UNIT"button to turn on/off the backlight.6.Clear screen dataAfter start-up,press"CLR"button to clear the data displayed on LCD screen.7.Power off automaticallyThe instrument will power off automatically if two minutes no operation after start-up.And it will power off automatically as well after five minutes start-up,even when you are operating it. VC100 parameters and details
|