Rotatory Car Polisher 180mm disc Orbital Variable Speed 3000rpm Polisher

Features:

The AUTOCARE car polisher machine is the Rotary polisher with high power, high speed. Power supply protection cover for prolonging service life.

Specifications:

Material: ABS
Power input: 1200W
Voltage: 220/110V
Polishing orbits: 3000 rpm
Disk diameter: 180mm / 7 inches
Plug Available: EU &US (Please leave us a note which plug you need, or we will send EU plugs only, thank you)

Usage:

·Shake well and apply 4-5 drops of AUTOCARE Premium Polish to the wool pad.
·Prime pad with Pad Conditioner.
·Dab product out evenly across 2' x 2' section.
·Turn on the machine on surface, start with setting 1 to spread the polish.
·Increase speed and using moderate pressure.
·Operate within the working area 2-3 times until the polish is consumed. ·Remove residue with a clean AUTOCARE microfiber towel.

Packing list:

Option 1:

1 x AUTOCARE Polisher

1 x Self-adhesive Disk

1 x Wrench

1 x Side handle

1 x Wool pad

1 x Waxing Flat pad

1 x Box

Option 2:

1 x AUTOCARE Polisher

1 x Self-adhesive Disks

1 x Wrench

1 x Side Handle

1 x Wool Pads

2 x 7~8" Microfiber Bonnets

2 x 7~8" Cotton Bonnets

2 x 7~8"Wool Bonnets

Option 3:

1 x AUTOCARE Polisher

2 x Self-adhesive Disks

1 x Wrench

1 x Side handle

2 x Wool pads

3 x Waxing Flat Pads

1 x Polishing Wavy Pad

2 x 7~8" Microfiber Bonnets

2 x 7~8" Cotton Bonnets

2 x 7~8"Wool Bonnets

Instructions：

Tips:

Cleaning

The power tool's air inlets should be cleaned after use to safeguard good air circulation. After each use, the machine should be cleaned using a soft, damp cloth. Never use solvents such as alcohol or petrol. These could damage the plastic parts.

Technical Support

You can address minor faults by yourself and use the following overview:
·The power tool is not working：
-Check whether the voltage indicated on the model plate corresponds with the voltage of the power supply.
-Check the power tool and cables for damage.
·The motor does not reach the maximum speed.
-The extension cable is too thin or too long.
-The mains voltage is less than 230 Volts.
·The power tool has overheated.
-The air holes are clogged and should be cleaned using a damp cloth.
-The power tool is overloaded. Only use the power tool for purposes for which it is suitable.
·The motor is noisy and rotates irregularly.
-There is dirt in the motor or the carbon brushes are worn.
The carbon brushes should be replaced if the power tool is not working.