Fitment:

For Yamaha FZ8 non ABS 2010-2015
For Yamaha Bolt non-ABS 2013-2016
For Yamaha YZF-R1 1998-2008
For Yamaha Bo1100 Bulldog 2002-2006
For Yamaha Delverslon not-ABS 2009-2015
For Yamaha Dyag Star 1999-2006
For Yamaha Fjr1300 non-ABS 2001-2005
For Yamaha Fjr1300 ABS 2003-2005
For Yamaha Fz-16/FZ-S 2008-2015
For Yamaha Fz400 1997-2002
For Yamaha Fz6 non-ABS 1998-2012
For Yamaha FZ6r 2009-2016
For Yamaha Stryker 2011-2016
For Yamaha Fz8 non-ABS 2010-2015
For Yamaha Fz1 2001-2016
For Yamaha Fzh150 2015
For Yamaha Fzn150 2015
For Yamaha Fzs600 Fazer 1998-2003
For Yamaha Fzs1000 Fazer 2001-2015
For Yamaha Mt-01 2005-2012
For Yamaha Mt-03 non-ABS 2006-2016
For Yamaha Ralder 2006-2016
For Yamaha Roadllner 2006-2015
For Yamaha Road Star 1999-2014
For Yamaha Royal Star All Varlants 1996-2013
For Yamaha V-Star 950cc and above All
For Yamaha Warrlor 2002-2012
For Yamaha Wr250r/x 2008-2016
For Yamaha Wr450r/x 2008
For Yamaha Xt660 2004-2015
For Yamaha Xv1600A wlld star 1999-2005
For Yamaha Xvs 950A Mldnight Star 2009-2016
For Yamaha Xvs 1300A Mldnight Star 2007-2015
For Yamaha Yzf-R6 1998-2016
For Yamaha Yzf-R6s 2006-2009
For Yamaha Stratollner 2006-2015
For Yamaha TDM990 non-ABS 2002-2013
For Yamaha TDM990 ABS 2002-2006
For Yamaha Xj6 non-ABS 2009-2015
For Yamaha Xjr400 2002-2007
For Yamaha Xjr1300 2004-2016
For Yamaha Xv1900A Mldnight Star 2006-2015
For Yamaha Xvs1100 Drag Star 1999-2006
For Yamaha Ys250 Fazer All

Feature:

Shows current gear number
Indicates current gear from 1 to max of 6. as well as a neutral indicator.
Auto programming
Compatible with all motorbikes,four wheeler,bikes etc. will fit anything with a shift lever
Detects the current gear faster than other gear indicators that use speedometer/tachometer signal.
Display can be mounted anywhere

Installation:

To find the gear display plug as to the product and then connected to a power line and speed signal line is inserted in the tank below!When the monitor is in place,check that the cable is not subject to steering damage!

Steps:

You need to setup this module after installation.Perform the setup only when the engine is WARM so the idle speed is normal,Find a long,straight road with light traffic.The unit does not learn the same gear twice,this makes it easy to set up on the road.You can even shift down and stop during the setup if needed.Do not stare at the display,watch the road and ride with extreme care as always!Turn the ignition On.The display counts backwards(6 to 1)indicating that the memory is clear. When "L"is flashing,stare the engine in Neutral and let the engine idle. When the display is flashing "1",select second gear. Release the clutch and stare riding normally. The display is blinking faster while the unit is learning the gear. When the display show "n"(next),select second gear. Repeat this process until all gears are thought. In top gear, wait until "o"(over) is indicated and the display stops blinking.The unit is now programmed and should indicate all gears correctly. When ignition is turned on,the display counts forward(1 to 6)indicating that it is programmed and fully functional.

Reset

If some gears are not indicated correctly, reset the unit and set it up again. If you change your gearing (install new front or rear sprocket),or you install a speedometer (or other speedometer calibrator), probably you will have to reset it and set it up again. Cut off the power of the unit 6 times in a row, while the display is counting up and shows 3 ,4 or 5.You can power on/off the display by turning the ignition key on/off. On the next power up, the display will count backwards(6 to 1). The memory is clear now and you can perform the Setup procedure.

Warranty:

The unit is completely sealed and epoxy encapsulated,which gives extreme protection for the internal parts from shocks,vibrations and water. To ensure trouble-free operation from the start,all units have been extensively tested prior to shipment.Our dealers are offering a 30-day money-back guarantee on Heal Tech products,thus you will get your money back if the product does not fulfill your expectations.( ALL parts must be returned in original condition for full refund) .

Package List:

1 x Motorcycle Speed Gear Display + Holder

Product plug show