Fuel Gauge Interface Module Ohm Range Converter for Any Fuel Gauges to Match Specific Ohm Range

Features

1. Acts as Interface Between Fuel Senders & Gauges 2. Reads any fuel sender 3. Works with any fuel gauge 4. Accurately Corrects OHM Mismatch & Erratic Movement from Fuel Slosh 5. Custom Calibration for empty, half level and full 6. Mini Size 20(w) x 16(H) x35(L) mm - Fuel Gauges are designed to work with a specific ohm range. - Different automobile and gauge manufacturers use different ohm ranges to correctly operate their gauges. This can cause problems for a person who is updating their vehicle with new gauges or a new gas tank and fuel sender. - This module will allow you to use your stock sender with any fuel gauge and vice versa.

Instructions

1/Mount module in a clean dry cool position. 2/Connect wires as guide photo above 3/Using store mode,program and store Full,Half,Empty and “Power on” positions. 4/Using power on mode,program how you want the gauge to operate when car is started. 5/Operated in run mode and check. IMPORTANT NOTICE When adjusting the screw, move gauge from Full to Empty to avoid hysteresis error. Some gauges are very slow to move. Please allow time to stabilize. The tank sender must have the same Ground as FM101 , otherwise erratic readings will result.

Run mode

1/Power off, Wait 5 seconds, then power on. 2/Green LED will turn on.

Power on mode

1/Power off. Wait 5 seconds. 2/Choose where you want the gauge to start from when the car is started(Usually the gauge "off position" ) lf you want the gauge to start at sender position.(suits bi-metal and cross coil gauges with damping) Press "E" switch and power on,release “E” switch. lf you want the gauge to start at the preset position(set in store mode step /6).(suits gauges with no damping)Press “H" switch and power on,Release“H" switch. 3/Green LED will turn on.

Picture

Shipping

Payment