feature:

1. T-shaped design: The car windshield sealing strip adopts at-shaped design, and the reasonable T-shaped design can better fit the gap of your car, mainly used to seal the door, hood, trunk, window and door gap between frame

2. High-quality material: The car front windshield strip is made of EPDM rubber material, which has good elasticity and toughness, easy to fold and bend, safe and non-toxic, durable and strong, not easy to deform, and has a good sealing effect, such as waterproof and dustproof , sound insulation, windproof, long-term service

3. Easy installation: The door seal is designed with double-sided tape, which has good adhesion. You can directly stick the tape on the car without spending too much time. The use method is simple, the double-sided tape is soft and elastic, and will not damage your car. paint

4. Increase the tightness of your car, reduce the transmission of road and wind noise to the car, improve driving comfort, and prevent dust and rain in the car. The front and back covers can be sealed, and the waterproof, dustproof and sound insulation effect is good.

5. Main function: The advantage of using T-shaped sealing strip is to make the vehicle more airtight, reduce noise, prevent dust, water leakage, air leakage, and make the car more quiet and comfortable

Install:

1. Use a mild detergent to clean the door frame of dirt, dust and grime.

2. Double-sided tape for sealing strip.

3. Tear off one end of the sealing strip to determine the position of the protective film attached to the door frame, and then tear at the same time according to the installation line of the protective film, and press it to ensure the sealing installation and contact.

4. It is forbidden to pull the sealing strip by hand after pasting, and it is forbidden to rinse with water within 24 hours within 3 days, and try not to open and close the door repeatedly.

parameter:

Name: car seal

Size: 14mm/19mm

Specifications: 3 meters, 5 meters, 7 meters

Material: Rubber

Precaution

Tip: It is very important to consider the location when installing. Wipe with a towel to ensure that the surface is clean and flat. If the surface is not smooth enough, you need to use a tackifier to increase the viscosity; the temperature drops below 50 degrees Fahrenheit (10 degrees Celsius) in winter, at this temperature You can use a hot air gun to add some glue to stick more firmly