Car Circuit Fault Finding Auto Current Tester Automotive Repair Fuse Leakage Detector Diagnostic Tools
Feature:
High quality.
It is characterized by fast measurement speed and high accuracy.
It is very easy to use and can check the current through the car fuse.
Ideal for fault finding on automotive or commercial vehicle electrical circuit.
Specification:
Type: Current Tester
Color: Red
Cable length: 81.5cm
Size: 73x41x22.5mm
Measuring range: 0.01A-19.99A
Maximum load: 20A/48VDC lasts for 10 seconds
Power supply: 1 23A 12V battery (not including battery)
Operating temperature: 0C-40C
Working relative humidity: <75%
Storage temperature: -10C - 50C
Storage relative humidity: <80%
Operation instruction:
Operation Instruction
1.Turn off the vehicles' engine.
2. Take out the fuse and put it in slot of the AE150. Please make sure the circuit protection is correct . (The detection fuse of the tester is 20A/48 V, standard type)
3. Insert the plug of the tester into the vehicle fuse socket.
4. If necessary, start the vehicle engine and energize the circuit first. Then turn on the detector by pressing the power switch
5.Under test, operate the circuit and the display will show the measured current.
6. Turn off the tester by pressing the power button again when you finish the measurement.
Note:
Due to the different monitor and light effect, the actual color of the item might be slightly different from the color showed on the pictures. Thank you!
Please allow 1-3cm measuring deviation due to manual measurement.