- 0Cart
-
Your shopping cart is empty.
-
more items in the cart...
Cart Total: $0.00
Proceed to Checkout
Your shopping cart is empty.
Cart Total: $0.00
Proceed to Checkout
Item specifics
Product Description
KINGBOLEN BF 100 Brake Fluid Tester description :1. 5 STATUS EXPLANATION : With multiple L ED indicators, the measurement results are more accurate and more convenient to use! Red: Brake oil with at least 4% water content Red: Brake oil with about 3% water content Yellow: Brake oil wif about 2% water content Yellow: Brake oil wif less than 1% water content Green: Without water good condition LED Display Explanation: Green: The current test brake oil is in good condition. Green/ Yellow: Brake oil wif less TEMPthan 1% water content, Brake oil performance is good, you can use it wif confidence. Green/Yellow/Yellow: Brake oil wif about 2% water content, still able to work. Green/ Yellow/ Yellow/Red: Brake oil with about 3% , It is recommended to replace the brake fluid. Green/ Yellow/ Yellow/Red/Red: Brake oil with at least 4%, replacedimmediately. High Precision Probe:WIDE RANGE TES: Support DOT3、DOT4、DOT5.1 different brake fluid:DOT3 is the most common type of brake fluid used by daily drivers. DOT4 has a higher boiling point and has found its place in racing vehicles and police cars DOT5.1 : It is important never to mistake DOT 5.1 (glycol-based) with DOT 5 which is sllicone-based and should never be Mixed with any other DOT fluid. Standards: Minimum Boiling Points by Brake Fluid Type Simple Button:Easy to use How to Operate KINGBOLEN BF 100 Brake Fluid Tester ?( More one test, less worry; more cautious, less accidental! ) 1. HOW TO USE: Step 1: Put 2 pcs AAA batteries into main unit. Step 2: Deep press the power button for 3 sec to power ON the unit. Step 3: One press the power button to select the current oil type. Step 4: Insert the test probe into the brake fluid (wipe the probe clean, otherwise it will affect the results) Detect the result by LED display. Step 5: Hold pressing power button 2 seconds to turn on / off the LED flashlight. Step 6: Deep press the power button for 3 sec to power OFF the unit. 2.TIPS: Tip 1: After each test, please wipe the probe clean to avoid the residual stains effecting the next use Tip 2: If device not use for a long time, it is recommended to take out the battery and store the product in a dry place Parameters: |