All in One  48v 60v 72v Dual Drive Controllers Dual driver Driver With Thumb Accelerator LCD Display For Dual E Bike Scooter

Kindly please note,

a, this controller needs work with hall sensor, please don't buy it if there is no hall sensor wire from your motor.

Please don't buy it if motor is 24v 36v

b, we didn't suggest buy this controller if single motor power below 1500w,the current is larger for motor power below 1500w and the power consumtion is faster. Please choose the one for 500w-1200w (there is 36v 48v 500w-1200w dual drive design in our store).

What's included in the package?

1 piece 48v 60v dual drive controller+lcd display

2 pcs 3 wire mount box

Technical data of the hub motor,
Voltage: 48v60v/60v72v

Low Voltage, 40v/52v/64v
Suitable for motor power 1500w-3500w

Max current 50A for single side motor
Angle 120 degree

controller size, 170*100*50mm, wire length 12-15mm

Function of the controller

Single/dual drive choice

Auto-learn wire

Soft/hard start

Standard by accelerator

Accelerator Lcd display

LCD DISPLAY SETTING

Parameter settings

Long press and key to enter the internal parameter setting

P01: Backlight brightness adjustment, 1 is the darkest, 3 is the brightest;

P02: Mileage unit, 0: KM; 1: MILE;

P03: Voltage  48V，60v，72v

P04: Sleep time: 0 means none, other numbers are sleep time 1-60 minutes;

P05: Assist gear: 3, 5, 9 optional, original is 3

P06: Wheel diameter: unit, inch; precision: 0.1;

P07: Number of speed measuring magnets: 1-100 optional;

P08: Speed limit, the range is 0-100km/h, 100means no speed limit (this parameter is based on kilometers)

P09: Zero/non-zero start setting, 0: zero start; 1: non-zero start;

P10: drive mode setting, 0: Assitant start; 1: electric drive; 2 coexistence of boost and electric drive;

P11: Resistance sensitivity setting, range 1-24;

P12: resistance start strength setting, range 0-5;

P13: Power-assist magnetic steel disc type setting, 5, 8, 12 three types of magnetic steel quantity;

P14: Controller current limit value setting, range 1-100A;

P15: Not open for the time being;

P16: ODO reset Press and hold the key for 5 seconds to reset ODO and total time TTM;

P17: cruise function setting, 0: no cruise; 1: cruise;

Fault code

E-01 Motor fault ( usually it is phase wire not match, please also check if there is hall sensor or phase wire loosen)

E-02 Accelerator fault

E-03 Controller fault

E-05 Controller low voltage (Battery voltage is low or not work)

E-06 Communication fault, the lcd display can't receive the controller signal (It will also show E-06 when the battery fault)

E-07 Lcd display fault

Any question, please feel free to