The DHO control unit allows you to connect LED lamps or daytime running lights in such a way that they are turned on automatically when the engine starts.

With the DHO control unit, you can realize the function of driving LED headlights, using the connection of an additional yellow wire for example to + dimensions or + passing beam. That is, when you turn on the near or dimensions, daytime running lights will be flattened.

The DHO unit works on a car with a 12-18 v network voltage!

Please note! The DHO control unit will not work correctly on cars with generators with an intelligent charging system. If the voltage will fall below 13 v it will turn off.

Connecting:

1. connect two DHO into one wiring. If the DHO is already connected, no improvement is required.

2. connect wires from DHO to black and red wire from DHO controller where black "-" Red "+". If you have a set of DHO with a turn signal in the regular place of the lamp, only the red (+) wire is used. Minus Just isolate.

3. on the side where there are terminals and fuse on the controller, connect the wires to the battery where black "-" Red "+".

4. on the same side, connect the yellow wire to the positive contact of the passing beam of the headlights or to the position lamps.

5. isolate all connections.

Main characteristics:

-Maximum load: 5A (60 W)

-Voltage to turn on unit: 13.4 V

-Voltage to turn off the unit: 12.98 V

-Unit dimensions (LxWxH): 50x25x15mm

-Cable Length: 40 cm

Parcel includes:

-1 pc * S DHO control unit